SKU: WHT004835
Audi Genuine Hub and Bearing Mounting Bolt - WHT004835

This heavy-duty hardware is used to securely fasten and clamp the wheel bearing/hub assembly to the steering knuckle (spindle). It is used on both the left and right sides of applicable vehicles, typically on models featuring All-Wheel Drive (Quattro / 4Motion) configurations or specific large-rotor brake setups (e.g., 338x30mm or 360x34mm rotors).

Specifications

• Thread / Dimensions: M12 x 1.5 x 46 mm (Note: Depending on the catalog, the thread pitch is occasionally listed as M12x1.25, but it is an M12 bolt with a 46mm shank length).

• Material Type: High-tensile strength automotive fastener.

Important Installation Note

• Single-Use Hardware: This is a torque-to-yield (stretch) bolt. Factory service manuals dictate that this part cannot be reused or reinstalled. Once loosened or removed during a wheel bearing replacement or suspension teardown, it loses its required clamping elasticity and must be replaced with a new bolt to ensure driving safety.

• Brand: Audi

- No applicable data -